Manitowoc Published 11-20-19, Control # 234-19 4-55
MLC300 OPERATOR MANUAL SETUP AND INSTALLATION
Deploy Carbody Side Platforms
The carbody side platform assemblies (1, View A) are
shipped in the closed position attached to the carbody.
Deploy each carbody side platform assembly, as follows:
See Figure 4-41
for the following procedure.
1. Remove pins (2, View A) from the shipping holes (A).
2. Raise the platform assembly to the working position.
3. Install pins (2, View B) in the working holes B.
4. Rotate the folding platform (3) to the working position
(View C).
a. Remove the hair pin cotter (4, View D) pin (5) and
disconnect the link (6) from the pin.
b. Rotate the link (6, View E) down and pin it to the
stud (7) with hair-pin cotter (4).
5. Repeat the steps for the other carbody side platform.
6. DO NOT rotate the folding platforms (3, View C) to the
working position until after the crawlers are installed.
To Next Page
Loading...
Need help?
General
