Manitowoc MLC300 User Manual

Manitowoc Published 11-20-19, Control # 234-19 4-155
MLC300 OPERATOR MANUAL SETUP AND INSTALLATION
3
1
4
Move Rotating Bed Left-Front Ladder to
Working Position
See Figure 4-102 for the following procedure.
1. Remove the pins (10, View FW), raise the storage
brackets (9, View FS) to the shipping position, and install
the pins (10).
2. Remove the quick-release pins (6, View DW and EW)
and the padlock (7, View DW) to disconnect the left-front
ladder (5) from the support arm (8).
3. Lift the ladder away from the storage bracket (9, View
EW) and off the hooks on the left-front platform (1, View
FW). Place the ladder to the side.
4. Remove the quick-release pin (11, View DW), swing the
support arm in, and reinstall quick-release pin (11, View
DS).
5. Hook the left-front ladder (5, View FS) onto the storage
brackets (9).
6. Install the quick-release pins (6, View DS and ES) and
the padlock (7, View ES) to connect the left-front ladder
to the ladder support arm (8).
Move Rotating Bed Left-Front Platform to
Working Position
See Figure 4-102 for the following procedure.
1. Remove the quick-release pins (2, View AW).
2. Support the platform (1, View CW) with the platform
braces (4) so the platform cannot fall when the next step
is performed. The platform weighs 21 kg (46 lb).
3. Remove pins (3, View BW) to unpin the left-front
platform from the working position (View CW).
4. Lower the left-front platform (1, View CS) and the
platform braces to the shipping position.
5. Pin the platform braces (4, View BS) to the lugs on the
rotating bed with the pins (3).
6. Pin the platform (1, View AS) to the lugs on the rotating
bed with the quick-release pins (2).
Figure 4-102 continued
View AW
View BW
View CW
View DW
View EW
View FW

Manitowoc MLC300 Specifications

General

Brand	Manitowoc
Model	MLC300
Category	Construction Equipment
Language	English