Manitowoc MLC300 User Manual

Manitowoc Published 11-20-19, Control # 234-19 4-159
MLC300 OPERATOR MANUAL SETUP AND INSTALLATION
3
1
4
Install Carbody-Rotating Bed Module on
Trailer
See Figure 4-105 for the following procedure.
1. Using the remote control, fully extend the carbody jacks
(6, View E) to raise the carbody-rotating bed module.
2. Slowly and carefully drive the trailer (1, View C) into
position under the carbody-rotating bed module.
3. Install blocking as needed between the carbody-rotating
bed module and the trailer.
4. Retract the carbody jacks (6, View F) to lower the
carbody-rotating bed module onto the trailer.
NOTE A level is provided on the front of the carbody. See
Section 3 of the Crane Operator Manual.
5. Using the remote control, tilt the operator cab down onto
blocking placed under the lower front corners of the
operator cab frame.
Use care not to damage components under the
operator cab.
6. Secure the carbody-rotating bed module and the
operator cab to the trailer with tie-downs.
7. Using the remote control, fully retract the carbody jacks
(View D).
8. Store the jack pads (7, View B). Each jack pad weighs
45 kg (99 lb).
9. Remove the pins (5, View D) from the working holes (B).
10. Rotate the carbody jacks (6, View D) inward to the
storage position.
11. Install the connecting pins (5, View D) in the storage
holes (A).
Store Remote Control
1. Using the external engine switch (8, Figure 4-7 on
page 4-8), stop the engine.
2. Remove the key from the external engine switch.
3. Turn off the remote control.
4. If the electric cable is being used between the remote
control and the transceiver, disconnect the cable from
the transceiver.
5. Store the remote control and the electric cable (if used)
in the compartment on the left side of the operator cab
(see Figure 4-7 on page 4-8
).
6. Lock the compartment and remove the key.
Final Checks
1. Verify that all loads are securely tied down to the trailers.
See Shipping Crane Components on page 4-111
.
2. Make sure all required parts are stored in the parts box.
See Parts Box on page 4-4
.
WARNING
Moving Part Hazard!
To avoid serious crushing injury — warn all personnel to
stand clear of the jacks.
WARNING
Tipping Hazard!
Avoid tipping the crane over — keep the crane level while
jacking.
CAUTION
Avoid Structural Damage
Do not extend the carbody jacks when they are stored.
Serious structural damage will occur to the carbody and
jacks.

Manitowoc MLC300 Specifications

General

Brand	Manitowoc
Model	MLC300
Category	Construction Equipment
Language	English