EasyManuals Logo
Home>Manitowoc>Construction Equipment>VPC-MAX MLC650

Manitowoc VPC-MAX MLC650 User Manual

Manitowoc VPC-MAX MLC650
234 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #127 background imageLoading...
Page #127 background image
Manitowoc Published 04-06-18, Control # 231-14 4-69
MLC650 VPC-MAX™ OPERATOR MANUAL SET-UP AND INSTALLATION
4
Legend for Figure 4-61
Moving the Equalizer to the Equalizer Rails
See Figure 4-61 for the following procedure.
1. If stored, remove the rear stop pins (1, View E) from the
rear storage tubes (2) and install the pins in the rear
holes of the rails (3).
If equipped with rollers (1A, View E-E) install the rollers
over the rear stop pins as the pins are installed. The
rollers are stored in the parts box.
2. Leave the front stop pins (1, View D) stored in the front
storage lugs (2).
3. Pay out the mast hoist wire rope to lower the masts (4
and 5, View B).
4. At the same time, haul in the boom hoist wire rope to
raise the equalizer (6).
5. Stop lowering the masts when the fixed mast (5, View B)
is at 39.7°.
6. Connect two SL 6 slings (8, View A) from the hook of the
assist crane (9) and to the front two lifting lugs (10) on
the equalizer (6).
7. Slowly lift the equalizer with the assist crane until the
equalizer is horizontal as shown in View A.
8. Slowly pay out the boom hoist wire rope from the
MLC650 and lower the equalizer (6) with the assist
crane until the equalizer is resting on the rails (3, View
C).
9. Make sure the equalizer is on the forward side of the
rear stop pins (1, View D).
10. Slacken the boom hoist wire rope and the SL 6 slings so
the equalizer cannot slide rearward.
11. Remove the front stop pins (1, View E) from the front
storage tubes (2) and install the pins in the front holes of
the rails (3, View D) and the equalizer (6).
12. Disconnect the SL 6 slings (8, View A) from the
equalizer (6).
Item Description
1 Stop Pin with Safety Pins (4)
1A Roller (2) (if equipped)
2 Storage Tube (4)
3Rails (2 sets)
4Live Mast
5Fixed Mast
6 Equalizer
7 12 m Insert Equalizer Insert
8 SL 6 Sling – 5 m (16.40 ft), 31 751 kg (70,000 lb) (qty 2)
9 Assist Crane Hook
10 Lifting Lug (front 2)
11 39.7° Minimum Mast Angle
CAUTION
Mast Damage!
Do not lower the fixed mast below 39.7° during the
following steps. Structural damage could result.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Manitowoc VPC-MAX MLC650 and is the answer not in the manual?

Manitowoc VPC-MAX MLC650 Specifications

General IconGeneral
BrandManitowoc
ModelVPC-MAX MLC650
CategoryConstruction Equipment
LanguageEnglish

Related product manuals