Manitowoc Published 04-06-18, Control # 231-14 4-133
MLC650 VPC-MAX™ OPERATOR MANUAL SET-UP AND INSTALLATION
Removing the VPC-MAX Beam
Drawing the VPC-MAX Beam off the Rotating Bed
See Figure 4-112 for the following procedure.
1. Attach the two plates from the counterweight tray to the
assist crane.
2. Attach two of the pendants (1) from the counterweight
tray to one of the plates and to the rear lifting lugs (4) on
the VPC-MAX beam (2).
3. Attach the other two pendants to the other plate and to
the first two pendants so the second pendants cannot
swing freely.
4. Using the assist crane, hoist just enough to raise the
beam off the pins at the rear of the rotating bed.
5. With the assist crane continuing to support the rear of
the beam, slowly drive the actuator (3) rearward using
the remote control.
6. Stop when the actuator is at the beam removal/
installation position of 8.70 m as shown in the VPC-MAX
Calibration Screen of the Main Display (View B,
Figure 4-24 on page 4-23
).
FIGURE 4-112
Item Description
1 Pendant (qty 4)
2 VPC-MAX Beam
3 Actuator
4 Lifting Lug (qty 4)
To Next Page
Loading...
Need help?
General
