model no. 055-6768-8 | contact us 1-800-689-9928
18
AMPERAGE (AMPS) – A measure of the flow of electric current. Higher ratings
generally mean the tool is suited for heavier use.
ARBOUR LOCK – Allows the user to keep the blade from rotating while tightening or
loosening the arbour bolt during blade replacement or removal.
BASE – Supports the table, holds accessories and allows for workbench or leg set
mounting.
BEVEL LOCKING HANDLE – Locks the mitre saw at a desired bevel angle.
BEVEL SCALE – To measure the bevel angle of the saw blade 0° to 47° left and right.
CARBIDE TIPPED – Extremely hard steel pieces with sharp cutting edges fastened to
cutting tools such as saw blades.
COVER PLATE SCREW – Loosen this screw and rotate the plate for access to the blade
arbour bolt.
DOUBLE INSULATED – A form of electrical protection featuring two separate insulation
systems to help protect against electric shock.
EXTENSION CORD – An electric cord used between power tools and outlets to extend
the range of the tools. The more amperage your tool uses and the longer the distance,
the larger the size of the wire needed in your extension cord.
EYE PROTECTION – Goggles or spectacles intended to protect your eyes. Eye
protection should meet the requirements of ANSI Z.87.1 (USA) or CSA Z94.3-M88
(Canada).
FACE SHIELD – An impact-resistant shield that helps to protect your face from chips,
sparks, and small debris. Should only be used in conjunction with additional eye
protection.
FENCE – Helps to keep the workpiece from moving when sawing. Scaled to assist with
accurate cutting.
GUARD – Protective device that forms a barrier between a hazardous object such as a
blade, wheel or cutter and the operator.
HOLD-DOWN LATCH – Locks the mitre saw in the lowered position for compact
storage and transportation.
INSTRUCTION OR OWNER’S MANUAL – Booklet accompanying your power tool that
describes the hazards and safe operation procedures, outlines basic tool operation,
care and maintenance.
MITRE HANDLE – Used to rotate the table, and to rotate the saw to a right or left
cutting position.
MITRE SCALE – Measures the mitre angle 0° to 50° left and right.
MOUNTING HOLES – To mount the mitre saw to a stable surface.
ON/OFF TRIGGER SWITCH – To start the tool, push the safety lock-off button and
squeeze the trigger. Release the trigger to turn off the mitre saw.
GLOSSARY OF TERMS
To Next Page
Loading...
Need help?
General
