56
model no. 055-6768-8 | contact us 1-800-689-9928
MAINTENANCE
LOWER BLADE GUARD
Do not use the saw without the lower blade guard. The lower blade guard is attached
to the saw for your protection. Should the lower guard become damaged, do not use
the saw until the damaged guard has been replaced. Regularly check to make sure the
lower guard is working properly. Also check before each use that all bolt/screws are
tight. Clean the lower guard of any dust or build-up with a damp cloth.
SAWDUST
Periodically, sawdust will accumulate under the work table and base. This could cause
difficulty in the movement of the worktable when setting up a mitre cut. Frequently
blow out or vacuum the sawdust.
If you need to remove small pieces of material from the table cavity, see the section on
Removing and Installing the Table Insert on page 23.
To empty the dust bag, remove the sawdust bag from the dust port. Open the zipper
on the sawdust bag and empty out the sawdust inside. Close the zipper and reinstall
the dust bag on the dust port as described on page 19.
WARNING:
• When cleaning the lower guard, unplug the saw from the power
source receptacle to avoid unexpected start-up.
• Do not use solvents on the guard. They could make the plastic
“cloudy” and brittle.
WARNING:
Wear proper eye protection to keep debris from entering eyes when
removing sawdust from unit.
To Next Page
Loading...
Need help?
General
