Your oven is equipped with a steam
injection system for cooking with
moisture. Baking, roasting and cooking
with Moisture plus d guarantees
optimised steam and air conduction for
excellent cooking and browning results.
After selecting Moisture plus d you
need to set the number of bursts of
steam.
You can select:
–
Automatic burst of steam (Aut§)
This requires enough water for one
burst of steam. The burst of steam
will be injected into the oven
automatically after the heating-up
phase.
– 1 burst of steam (i)
2 bursts of steam (2)
3 bursts of steam (3)
You need to add the appropriate
amount of water
First set the temperature and start the
water intake process. Water is taken in
via the tube underneath the control
panel on the left.
,
Use only fresh tap water when
cooking with the Moisture plus
function. Other liquids will cause
damage to the oven.
The water is then injected as bursts of
steam into the oven compartment
during the cooking programme.
The steam inlets are located at the rear
left corner of the roof of the oven.
Moisture plus d
56
To Next Page
Loading...
Need help?
General
