Preparing and starting the water
intake process
The prompt for the water intake process
will appear. The triangle V will flash
under ?.
?
;
^
Open the door.
^
Pull the water intake tube forwards
(located below the control panel on
the left).
^
Immerse the end of the water intake
pipe in the container with tap water.
^
Touch the OK sensor.
The water intake process will begin.
The amount of water required will be
drawn up into the oven. The quantity of
water specified is higher than actually
required, leaving a small amount in the
container.
The water intake process can be
interrupted and restarted at any time by
touching OK.
^
Remove the water container after the
water intake process.
^
Close the door.
You will hear the pump briefly as the
remaining water in the water intake tube
is drawn into the oven.
The appliance begins to heat up.
The current temperature and the
temperature indicator light 3 will
appear.
3
92
°C
You will see the temperature
increasing. A buzzer will sound when
the oven temperature is reached if this
option is selected (see "Settings P2").
Moisture plus d
59
To Next Page
Loading...
Need help?
General
