Malfunctions
49
Pictogram Meaning Possible cause Remedy
Internal water
treatment is
exhausted
Low salt
Fill the salt reservoir with
regenerating salt ( 6.2).
Integrated water
treatment
exhausted
1
The water back-flow counter reads
0.
12.7
Service interval is
running out
The number of operating hours /
washing cycles set in the controls
has been reached.
INFO: This function is not
activated in factory.
Contact an authorised service
technician for the maintenance.
Need for descaling
The number of operating hours set
in the control system has been
reached.
Starting the descaling programme
( 12.5.1).
Lower spray arm is
blocked
Spray arm is not correctly
engaged
Correctly engage the spray arm.
Spray arm obstructed by, e.g. a
piece of cutlery
Remove the obstruction.
Spray arm blocked by soiling
Clean the spray arm bearings
( 8.2).
Upper spray arm is
blocked
Spray arm obstructed by, e.g. high
dishes
Remove the obstruction.
Spray arm blocked by soiling
Clean the spray arm bearings
( 8.2).
The strainer is
blocked
Heavily soiled strainer
Remove, clean and replace the
strainer
Energy optimization
2
On-site energy optimisation
equipment switches individual
electrical consumers (heating
elements).
Wait until the on-site energy
optimisation equipment switches
off.
Malfunction with
error code
Various
Display the error code ( 9.1) and
assign the repair to an authorised
service technician.
9.1 Accessing the error code
In the display, the following symbol flashes:
Tap the following buttons in turn:
The error codes are displayed in area (a).
INFO Malfunctions already resolved are also displayed
here (e.g. ERR 1 OK).
Contact an authorised service technician for the repair.
Press the button (b) twice to leave the menu.
1
is displayed only when the water back-flow counter has been programmed 12.7.
2
is displayed only when the machine is connected to an equipment with energy optimisation
To Next Page
Loading...
Need help?
General
