Mimosa Backhaul Help Content
Mimosa Backhaul Management
Copyright © 2014 Mimosa Page 139
Network Interfaces
The Network Interfaces panel contains controls for changing data port status and speed.
B11
Ethernet Port - Set the Ethernet port transfer rate or allow it to be automatically determined. Manually
●
selectable options are 10, 100, or 1000BaseT at either full or half duplex. Note that Auto or 1000BaseT/Full is
recommended so that the Ethernet port does not create a bottleneck.
Fiber Port - Enable this option to route all data through this port with optical fiber and a small form-factor
●
pluggable (SFP) media adapter. Note that when using the Fiber Port, the Ethernet cable must remain connected
to the Ethernet Port to supply power.
To Next Page
Loading...
Need help?
General
