EasyManuals Logo
Home>Mimosa>Network Hardware>Backhaul B5c

Mimosa Backhaul B5c User Manual

Mimosa Backhaul B5c
240 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
Mimosa Backhaul Help Content
Mimosa Backhaul Setup
Copyright © 2014 Mimosa Page 2
Default IP Address
Mimosa backhaul radios can be accessed either via the wired interface or the 2.4 GHz wireless interface (if
applicable). An internal bridge connects the two interfaces. Each interface is assigned a default IP address (see table
below), and both addresses respond via either interface. The wired interface can either be set manually to a static
IP or changed dynamically via DHCP. The wireless interface IP can not be changed.
Notes:
Notes:
1. The wired Ethernet interface is configured by default to use DHCP with a static failover to the IP address
1. The wired Ethernet interface is configured by default to use DHCP with a static failover to the IP address
in the table below.
in the table below.
2. If applying power to the radio without populating the PoE Data port, the recovery page will be shown via
2. If applying power to the radio without populating the PoE Data port, the recovery page will be shown via
the wireless interface for 5 minutes. This behavior is normal and is a part of the Reset process. In this
the wireless interface for 5 minutes. This behavior is normal and is a part of the Reset process. In this
case, the default wireless IP will be 192.168.26.1.
case, the default wireless IP will be 192.168.26.1.
Value Wired Ethernet 2.4 GHz Wireless*
IP Address 192.168.1.20 192.168.25.1
Subnet Mask 255.255.255.0 255.255.255.0
* Does not apply to B5-Lite.
IP Address Discovery
Run the following command from the command line to discover the IP addresses of any directly connected Mimosa
devices. The string "20:B5:C6" is an Organizationally Unique Identifier (OUI), which is the first half of the MAC
address assigned to Mimosa devices. After executing the command, the IP address will be shown for each device.
Windows / DOS:
arp -a | findstr 20:B5:C6
Mac / Linux:
arp -a | grep 20:B5:C6
Port Scan
Run the following command from the command line to discover the port of any directly connected Mimosa devices.
This is especially useful if the port has been changed, and you do not remember the port number.
nmap 192.168.1.20

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mimosa Backhaul B5c and is the answer not in the manual?

Mimosa Backhaul B5c Specifications

General IconGeneral
BrandMimosa
ModelBackhaul B5c
CategoryNetwork Hardware
LanguageEnglish

Related product manuals