Mindray DC-45 User Manual

3-6 System Preparation
waiting time set for screensaver, and if there is still no operation, the system
enters standby after the waiting time for standby.
z Press the power button and select “Standby”.
z Disconnect the power plug, and select “Standby” in the prompted dialogue box.
When the system enters the standby status, the standby status indicator blinks in
orange.
 To exit standby
z Press the power button.
 When the system enters the standby status, if need to power off:
z Long press the power button for 5s.
z Press the power button to exit the standby status and then power off the system.
NOTE: 1. Power off the system if you will not use the system for a long period of time
(including storage/ transportation conditions), and you should not allow the
system in standby status, otherwise the batteries will be out of power and
permanently damaged.
2. If you will not use the system for a long period of time, DO NOT leave the
system in standby status, you should shut down the system, disconnect
mains power, and turn off powers of all connected peripherals.
3.4 Monitor Adjusting
3.4.1 Monitor Position Adjusting
Gently hold the bottom edge of the monitor when adjusting its position.
 Rotate the monitor
z Monitor rotation
The monitor can be rotated ±90° .

Mindray DC-45 Specifications

General

Brand	Mindray
Model	DC-45
Category	Medical Equipment
Language	English