NOTE
Adjust the position of the GA 10 on the shaft
until it is comfortable when swinging the
detector.
Store the GA10
To clip the GA 10 to the detector, lay the GA 10 shaft
parallel to the detector’s shaft and slide the C-clip into the
guide arm attachment point on the detector.
PRO‑SWING45
The GPZ 7000 comes with a PRO-SWING 45 harness that
evenly distributes the weight of your detector from your
shoulders, via the J-strut, making your detecting swing
lighter.
Weight distribution is further enhanced when the
PRO-SWING 45 is used with the included optional
attachments.
PRO‑SWING45 Optional Attachments
In Addition to the PRO-SWING 45 detecting harness, the
following attachments have been included:
• Extra J-strut
• Harness Crosspiece
These are designed to further reduce fatigue during long
detecting sessions by distributing the detector weight
more evenly over both sides of the body.
Refer to the PRO-SWING 45 Instruction Guide included
with your detector for information relating to the
assembly and fitting of the PRO-SWING 45 detecting
harness, extra J-strut, and Harness Crosspiece.
Assembly
8
To Next Page
Loading...
Need help?
General
