Minelab GPZ7000 User Manual

Attach Armrest
1. Lift the armrest lock until it is fully open. Slide the
armrest onto the rail on top of the chassis. Ensure
that the sloping sides of the armrest face toward the
control panel.
2. Slide the armrest along the rail so that it will be
positioned comfortably just below your elbow when
holding the detector.
3. Push down the armrest lock to secure the armrest in
position.
Adjust Armrest Strap
1. Undo the hook and loop armrest strap.
2. Tighten the strap until your arm is secure in the
armrest, and fasten.
TIP
To fit a smaller arm, the strap can be fitted
upside down and passed through the
armrest three times.
Connecting Headphones
The GPZ 7000 does not have a built-in speaker. There are
three ways you can listen to audio:
1. Headphones connected to the detector
2. The WM 12 speaker
3. Headphones connected to the WM 12
Detector Audio
You can connect headphones directly to the detector. To
do this, plug the headphone connector into the socket on
the headphone module at the rear of the detector.
If using waterproof accessory headphones, you will need
to remove the headphone module from the control box
and connect the headphones to the exposed headphone
socket, remembering to tighten the retaining rings.
Changing Coils
To change a coil, follow the ‘Assembling the Detector’ coil
attachment steps on page 4 in reverse to remove the
coil, then repeat the steps in order with the alternative
coil.
Always check that the coil connector is dry and free of grit
and dust before connecting to the detector.
NOTE
All Minelab GPZ coils come with the
lower shaft pre-assembled to the coil.
Disassembling a coil from its lower shaft is
not recommended.
WM12 Audio
NOTE
If you are using the WM 12 to listen to audio,
attach the WM 12 to the same side of your
body as the detector, using the supplied belt
clip. This will ensure the most reliable wireless signal.
Assembly
6

Minelab GPZ7000 Specifications

General

Brand	Minelab
Model	GPZ7000
Category	Metal Detector
Language	English