Minelab GPZ7000 User Manual

Create WayPoint
Use the Create WayPoint function to save
time and location information for a point
of interest. These are stored as WayPoints
in the GeoStore.
To Create a WayPoint:
You can cancel at any time during the Create WayPoint
process by pressing the Back button.
1. Press the Store button to display the Create GeoData
page.
2. Select the Create WayPoint function. The item name,
time, and location information will be displayed.
3. Press the Select button to save. A confirmation
message will be displayed. After a few seconds the
message will disappear and you will be returned to
the Create GeoData page.
Record GeoHunt
Use the Record GeoHunt function to
commence recording your detecting
activites and detector information to be
stored in the GeoStore for future
reference.
To Record a GeoHunt:
1. Press the Store button to display the Create GeoData
page.
2. Select the Record GeoHunt function.
3. The GPZ 7000 will record your detecting activities
until you pause or stop the GeoHunt. The Record
GeoHunt icon will replace the GPS icon in the Status
Bar and your movements will be displayed on the
Map as a red GeoTrail.
If you turn your detector off while you are recording a
GeoHunt, the GeoHunt will stop and be saved to the
GeoStore.
If you pause the GeoHunt before you turn the detector
off, the GeoHunt will remain active and the Pause
GeoHunt icon will appear in the Status Bar when the
detector is turned back on. You can resume recording the
GeoHunt.
Stop GeoHunt
Stop a GeoHunt at any time to cease
recording a GeoHunt. Once a GeoHunt
has been stopped, it cannot be resumed.
To Stop a GeoHunt:
1. Press the Store button to display the Create GeoData
page.
2. Select the Stop GeoHunt function.
3. The GPZ 7000 will cease recording your detecting
activities and the GPS icon will replace the Record/
Pause GeoHunt icon in the Status Bar. The stored
GeoHunt can be transferred to the XChange 2 PC
application for display, editing and storage. It can also
be shown on the Map via the GeoTrails function.
Pause GeoHunt
GeoHunts can be paused to temporarily
cease recording detecting activities.
To Pause a GeoHunt:
1. Press the Store button to display the Create GeoData
page.
2. Select the Pause GeoHunt function.
3. The GPZ 7000 will temporarily cease recording your
detecting activities and the Pause GeoHunt icon will
be displayed in the Status Bar.
To resume recording a paused GeoHunt, select Record
GeoHunt on the Create GeoData page. The Record
GeoHunt icon will be displayed in the Status Bar.
If you turn your detector off while you are recording a
GeoHunt, the GeoHunt will stop and will be saved to the
database.
If you pause the GeoHunt and then turn the detector
off, the GeoHunt will remain paused when the detector
is turned on again. You can then resume recording the
GeoHunt.
Loss of Power During a GeoHunt
In the event of the detector powering down or being
plugged into a PC while you are recording a GeoHunt, the
GeoHunt will stop and the logging of data will cease.
Create GeoData
44

Minelab GPZ7000 Specifications

General

Brand	Minelab
Model	GPZ7000
Category	Metal Detector
Language	English