Minelab GPZ7000 User Manual

Wireless Audio Module
The Wireless Audio Module (WM 12) receives wireless
audio using advanced Wi-Stream technology to achieve
clear sound with no perceivable time delay.
It contains an internal loudspeaker and ¼-inch headphone
socket for use with your choice of headphones. It can be
used with the supplied belt clip.
The WM 12 has 14 channels, which allows multiple
detectors to be used within the same vicinity without
degraded performance.
The WM 12 must be connected to the GPZ 7000 as
described below before it can receive wireless audio.
WARNING
Do not immerse the WM 12 in any
liquid or allow water ingress.
Power LED
Power Button
Connection
LED
Connection
Button
Belt Clip
Reset
Button*
* If you
experience
diculties with
your WM 12,
insert a paper
clip here to reset.
Connect the WM12
Ensure that your WM 12 battery is fully charged before
you go detecting. For instructions on how to charge your
WM 12, see page 10.
It is only necessary to perform the wireless connection
procedure once, and after a reset or firmware upgrade.
After initial connection, the detector and WM 12 will
connect automatically when the WM 12 is turned on.
To connect the WM 12 to your detector, navigate to
‘Connect WM 12’ in the Settings menu and select it to
start the Guide sequence.
During the Guide sequence, a random channel will be
displayed. To change the channel, press the left or right
Arrow buttons. Press Select to confirm the channel.
Connect WM 12 Guide sequence showing channel selection
A countdown bar will appear at the bottom right of the
guide screen. If the WM 12 does not connect before the
countdown is finished (20 seconds), you will be prompted
to select either Cancel or Retry. Select Retry to repeat the
Connect WM 12 guide sequence.
Use the Wireless function on the Settings page to
enable or disable wireless (page 28). Disabling wireless
when you are not using the WM 12 is recommended to
conserve detector battery life.
NOTE
The WM 12 Connection LED may flash red
occasionally when the WM 12 is working
correctly. This indicates an intermittent
deterioration in radio communications and
is for information only– it can be ignored unless it blinks
red persistently.
If the Connection LED blinks red persistently, the
connection to the detector has been lost. Select the
Connect WM 12 function to reconnect the WM 12.
A lost connection is also indicated by the Wireless icon on
the Status Bar (page 18).
Reset the WM12
If you experience any difficulties with your WM 12, reset
the device by using the end of a paper clip to press the
Reset button.
Wireless Audio Module
11

Minelab GPZ7000 Specifications

General

Brand	Minelab
Model	GPZ7000
Category	Metal Detector
Language	English