Mitsubishi MELSEC Q Series Programming Manual

5-30
SET
5.3.5 Setting devices (except for annunciators) (SET)
SET
Function
(1) When the execution command is turned ON, the status of the designated devices becomes
as shown below:
(2) Devices turned ON by the instruction remain ON when the same command is turned OFF.
Devices turned ON by the SET instruction can be turned OFF by the RST instruction.
(3) When the execution command is OFF, the status of devices does not change.
: Bit device number to be set (ON)/Word device bit designation (bits)
Setting
Data
Internal Devices
R, ZR
J\
U\G
Zn Constants
Other
BL, DY
Bit Word Bit Word
(Other than T, C)
––
Device Device Status
Bit device Coils and contacts turned ON
When Bit Designation has been Made for Word Device Designation bit set at 1
Basic
Process
High
performance
Redundant Universal LCPU
Command
SET D
SET
D
D
X5
X7
Command
Y10SET
Y10RST
X5 OFF
Command
X7 OFF
Y10 OFF
ON
ON
ON

Mitsubishi MELSEC Q Series Specifications

General

Brand	Mitsubishi
Model	MELSEC Q Series
Category	Controller
Language	English