Mitsubishi MELSEC Q Series Programming Manual

7-255
COSD(P)
1
2
3
4
6
6
7
8
7.12 Special function instructions 7.12.4 COS operation on floating-point data (Double precision) (COSD(P))
7.12.4 COS operation on floating-point data (Double precision)
(COSD(P))
COSD(P)
Function
(1) The COS (cosine) value of the angle specified by is calculated and its result is stored into
the device specified by .
(2) Angles designated at are set in radian units (degrees / 180).
For conversion between degrees and radian values, see the RADD and DEGD instructions.
(3) When the operation results in -0 or an underflow, the result is processed as 0.
Operation Error
(1) In any of the following cases, an operation error occurs, the error flag (SM0) turns ON, and
an error code is stored into SD0.
• The value of the specified device is not in the following range: (Error code: 4140)
0,2
-1022
| value of specified device | < 2
1024
• The value of the designated device is 0. (Error code: 4140)
• The result exceeds the following range (Operation results in an overflow):
2
1024
| Operation result | (Error code: 4141)
: Angle data of which the COS (cosine) value is obtained or head number of the devices where the angle data
is stored (real number)
: Head number of the devices where the operation result will be stored (real number)
Setting
Data
Internal Devices
R, ZR
J\
U\G
Zn
Constants
E
Other
Bit Word Bit Word
–– –– ––
–– –– –– ––
Universal
Basic
Process
High
performance
Redundant
LCPU
Command
Command
COSDP
COSD
COSDP
COSD S D
S D
S
D
S
D
S
D
COS (
)
+3
64-bit floating-point
real number
S
+2
S
S
+1
S
+3
64-bit floating-point
real number
D
+2
D
D
+1
D
S

Mitsubishi MELSEC Q Series Specifications

General

Brand	Mitsubishi
Model	MELSEC Q Series
Category	Controller
Language	English