Mitsubishi MELSEC Q Series Programming Manual

7-253
COS(P)
1
2
3
4
6
6
7
8
7.12 Special function instructions 7.12.3 COS operation on floating-point data (Single precision) (COS(P))
7.12.3 COS operation on floating-point data (Single precision)
(COS(P))
COS(P)
*1: Applicable for the Universal model QCPU, LCPU.
Function
(1) Returns the COS (cosine) value of the angle designated by and stores operation result at
device number designated by .
(2) Angles designated at are set in radian units (degrees / 180).
For conversion between degrees and radian values, see the RAD and DEG instructions.
Basic model QCPU: The upper five digits of the serial No. are "04122" or larger.
: Angle data of which the COS (cosine) value is obtained or head number of the devices where the angle data
is stored (real number)
: Head number of the devices where the operation result will be stored (real number)
Setting
Data
Internal Devices
R, ZR
J\
U\G
Zn
Constants
E
Other
Bit Word Bit Word
–– ––
*1
––
–– ––
*1
–– ––
Process
High
performance
Redundant Universal
Ver.
Basic
LCPU
Command
Command
COSP
COS
COSP
COS S D
S D
S
D
S
D
S
D
32-bit floating-point
real number
COS (
)
32-bit floating-point
real number
+1
+1
S
D
S
D
S

Mitsubishi MELSEC Q Series Specifications

General

Brand	Mitsubishi
Model	MELSEC Q Series
Category	Controller
Language	English