1 Press the Menu Select button directly below
Optn.
2
or to Dist frm here and press the
Menu Select button directly below Sel.
The display shows a list of waypoints.
3 or to the required waypoint and press the
Menu Select button directly below Sel.
The display shows the distance and bearing from the
current to the selected coordinates.
Location Feature in Emergency Mode
When the Emergency feature is activated by pressing
the emergency button, the radio exits the Location
menu and returns to the Home (default) screen so
that you can see which channel the emergency signal
is going out on.
However, you may re-enter the Location menu while
still in emergency mode, provided that Silent
Emergency has not been activated.
If you have turned Location off using the ON/OFF
menu key, it automatically turns back on when
Emergency is activated.
If there is a solid location signal during Emergency,
the current location and the location information
received is saved as Emergency and Last Known
Location waypoints, respectively.
Peer-Location on the Display (ASTRO Conventional
only)
This feature is only available for radio-to-radio voice
transmissions, dispatch call and selective call in
conventional ASTRO system. For radio-to-radio
transmission, in order to allow the radio to show peer-
location, the voice should be directly sent from one
radio to another radio without passing through any
infrastructure facility such as repeaters, phone or
DVRS system. Both the transmitting radio and
receiving radio must be configured to enable them to
send and/or receive the GPS coordinates. You can
check with your nearest qualified technician for more
details.
Note
If the receiving radio is operating in a Mixed
Mode channel, only if its voice transmission is
via conventional ASTRO system then it can
receive the location coordinates of its peers.
This feature is also operable in a Scan Active channel
or Scan Talkback channel.
To Next Page
Loading...
Need help?
General
