Switching Between Repeater or Direct
Operation Button
The Repeater Operation increases the radio
coverage area by connecting with other radios
through a repeater. The transmit and receive
frequencies are different.
The Direct or “talkaround operation” allows you to
bypass the repeater and connect directly to another
radio. The transmit and receive frequencies are the
same.
Perform one of the following actions:
• Press the preprogrammed Repeater/Direct
switch to toggle between talkaround and
repeater modes.
•
or to Dir and press the Menu Select
button directly below Dir.
The display shows Repeater mode if the radio is
currently in Repeater mode.
The display shows Direct mode and the Talkaround
icon if the radio is currently in Direct mode (during
conventional operation only).
Monitor Feature
Radio users who switch from analog to digital radios
often assume that the lack of static on a digital
channel is an indication that the radio is not working
properly. This is not the case.
Digital technology quiets the transmission by
removing the noise from the signal and allows only
the clear voice or data information to be heard.
Use the Monitor feature to make sure a channel is
clear before transmitting.
Monitoring a Channel
The following methods are options on how to monitor
a channel. The result of all the methods is the same.
You can use the options interchangeably depending
on your preference and the programmed functions.
• Monitoring a Channel with Monitor button.
a) Press the preprogrammed Monitor button.
b) Adjust the Volume Control Knob if necessary.
c) Press and hold the PTT button to transmit.
The LED lights up solid red.
d) Release the PTT button to receive (listen).
To Next Page
Loading...
Need help?
General
