Motorola APX4000 XH User Manual

Preparing Your Radio for Use
This section provides simple instructions to prepare
your radio for use.
Charging the Battery
Warning
To avoid a possible explosion:
• Do not replace the battery in any area
labeled hazardous atmosphere.
• Do not discard batteries in a fire.
The Motorola-approved battery shipped with your
radio is uncharged. Prior to using a new battery,
charge it for a minimum of 16 hours to ensure
optimum capacity and performance. For a list of
Motorola-authorized batteries and chargers available
for use with your radio, see Accessories on page
168.
Note
When charging a battery attached to a radio,
turn the radio off to ensure a full charge.
To charge the battery, place the battery (with or
without the radio) in a Motorola-approved charger.
The LED on the charger indicates the charging
progress; see the charger user guide.
Attaching the Battery
You can view the status of the IMPRES
™
battery if the
radio is using an IMPRES battery. See IMPRES
Battery Annunciator on page 160 for more
information.
1 Slide the battery into the radio frame until the latch
which is at the bottom of the radio clicks into
place.
Preparing Your Radio for Use
20
English

Motorola APX4000 XH Specifications

General

IP Rating	IP67
Operating Temperature	-30°C to +60°C
GPS	Yes
Bluetooth	Yes
Frequency Range	764-870 MHz
Dimensions	40 D mm
Encryption	AES, DES, ADP