13
Powering On/Off (On-Off/End/Home Key)
To p o w e r On, press and hold . Your MTP850 performs a
self-check and registration routine. After successful
registration, the MTP850 is in service.
To p o w e r Off, press and hold . You will hear a beep and
the Powering Off message is displayed.
Powering On (Emergency Button)
Press and hold the Emergency button to power On.
The MTP850 will power On in Emergency Operation or in
standard mode (as programmed).
Powering On with Transmit Inhibit (TXI) Active
Transmit Inhibit is a feature allowing you to switch off
transmission before entering a Radio-Frequency (RF)
sensitive area. To activate this feature, press and
select More... > Networks > TXI Mode > Activate.
Before using your MTP850 for the first time, remove the plastic
lens protector from the display, and charge battery overnight to
ensure battery is initialised to it’s full capacity.
Take care to clean the bottom connector frequently and
particularly prior to the programming procedure e.g. with a soft
brush (do not use fluids).
It is recommended to turn off the terminal before connecting any of
the accessories.
The terminal powers On and Off without visible and audible
notification if Covert Mode is activated. (Refer to “Covert Mode”
on page 39.)
Pressing the Emergency button, even if
Transmit Inhibit is activated, causes the
MTP850 to transmit immediately. The
MTP850 must NOT be within the RF sensitive
area when entering Emergency Operation.
To Next Page
Loading...
Need help?
General
