33
Entering Repeater Mode
When your MTP850 is in DMO enter Repeater
Mode in one of the following ways:
• From the Home display press Optns and
select Repeater Mode.
• Press the Menu button and select More... >
Networks > Repeater Mode.
• Press the One-Touch Button that is assigned to that
feature.
Monitor Option in Optns menu
From the Home display press Optns and select Repeater
Mode. Your options are:
•Off
• Monitor Only
• Monitor & Transmit
– repeater allows the user to transmit
by pressing PTT.
PTT Double Push
This feature, if enabled by your Service Provider, allows you
to send the tone when the radio is in idle or Group Call mode
by pressing PTT twice.
After the D-PTT tone is played, the user can press and hold
the PTT once again to get the permission to talk. Otherwise if
the user presses the PTT while the D-PTT tone is played, it is
ignored.
After D-PTT tone is sent keeping PTT pressed will result in
permission to talk. D-PTT tone is not audible on sending
radio.
The terminal can operate in only one of the following modes at a
time: Trunked Mode Operation, Direct Mode Operation,
Gateway Mode Operation, Repeater Mode Operation. For
security and operational reasons combining these modes is not
possible.
To Next Page
Loading...
Need help?
General
