9-2 WATERPROOF PROTECTION
NWD-107460-02E Installation
Caution: Before connecting the IF cable between the IDU and ODU,
using the circuit tester, check that the resistance of the I/F
cable between center conductor and insulation is more than
100 M
Ω
.
Note The self-bonding tape should be prepared by customer.
Fig. 9-1 Location of Connector for Waterproof (2/2)
ODU
IFL connector
This part should be wrapped the
self-bonding tape tightly, twice or
more around the IF cable
connector and IF IN/OUT
connector of the ODU for
waterproof.
For ODU (6-11 GHz)
For ODU (13-38 GHz)
(Bottom View)
IF cable
Self-bonding tape
ODU
Self-bonding tape
ODU
IF cable
In case of L
−angle
6-38 GHz BAND ODU
Self-bonding
tape
Stretch
Wrap twice the
IF IN/OUT
connector with
A half of tape width
ODU
Twice
Submission Prohibited
NEC Internal Use Only
To Next Page
Loading...
Need help?
General
