EasyManuals Logo
Home>NEC>Network Hardware>iPasolink 200

NEC iPasolink 200 User Manual

NEC iPasolink 200
166 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #35 background imageLoading...
Page #35 background image
ODU MOUNTING 5-13
Installation NWD-107460-02E
3 Holding the feed with hand, rotate the feed 90 degrees,
Check that the aperture part of the Transition hub is rotated 90 degrees, then fix it
with the screws that were loosened in step 2,
4 Check that the aperture part of the Transition hub is rotated 90 degrees, then fix it
with the screws that were loosened in step 2
Note When a large and a small gasket are included in the antenna package.
Please use the large one. (The small gasket is not used in antenna
mount.)
(2))
ODU Direct Mounting Type Antenna (ANDREW example #2)
Notes
1. The details are referred to the installation manual which is attached to
the antenna. The installation or removal of the antenna requires qualified
experienced personnel.
2. The antenna is set to V-polarization when shipped from the factory.
1 Keep the antenna stand horizontally,
2 Loosen six screws with Allen wrench until transition can rotate freely,
Notes
1. Do not remove the screw complete from the screw hole.
2. Because of the screwtight is applied, the strength to loosen screw is
necessary.
Polarization
V
Polarization
H
Top
Top
Submission Prohibited
NEC Internal Use Only

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NEC iPasolink 200 and is the answer not in the manual?

NEC iPasolink 200 Specifications

General IconGeneral
BrandNEC
ModeliPasolink 200
CategoryNetwork Hardware
LanguageEnglish

Related product manuals