[ 11 ]
Before you begin
3
2
Connect the charger to a standard
wall outlet. The battery power
indicator (or battery bar) appears on
the screen and starts scrolling.
3
When the battery is 80% charged the
battery bar stops scrolling.
Battery
full
appears also, if the phone is on.
To obtain 100% battery capacity, allow another 2 hours for a “trickle”
or “maintenance” charge.
4
Disconnect the charger from the phone.
If the battery is completely empty, it might take a few minutes before the
battery bar appears on the screen. For best performance, charge your
phone’s battery for 24 hours before using your phone. The charging time
depends on the charger and battery that you use. For example, the charging
time for the BMC-2 battery with the ACP-8U charger is about 1 hour and
30 minutes.
Battery notes
Use the following guidelines to obtain the best performance from your
battery:
• With your phone turned off, charge your new battery for three hours
before its first use. Use the battery until it is fully discharged. Repeat
this procedure twice for a total of three charging cycles.
• Battery operation time may be less than the estimated times during
the first charges. This condition is normal.
• You can use your phone while the battery is charging. However, if the
battery is completely empty, it may need to recharge a few minutes
before you can make or receive calls or the battery indicator appears.
• After the first charge, you can make and receive calls during the charging
cycle, but the calls interrupt the charge. When the phone call ends, the
charge will resume.
To Next Page
Loading...
Need help?
General
