Oki Data CONFIDENTIAL
42930511TH Rev. 2 53 /
3. PRINTER INSTALLATION
3.1 Precautions and Prohibition
• Keep away from high temperatures and open flames.
• Please do not install in a place from which a chemical reaction is started (laboratory etc.).
• Do not install near inflammable solutions such as alcohol or thinner.
• Keep out of reach of children.
• Do not install on an unstable surface (the shaky stand, leaning place, etc.).
• Keep away from dust, humidity and direct sunlight.
• Keep away from the sea breeze and corrosive gases.
• Keep away from sources of vibration.
• Pull the power plug out of the socket and contact with a customer's service centre when the printer
is dropped or the cover is damaged.
There is a risk of getting an electric shock and/or causing fire leading to personal injury.
• Do not use a power code, a printer cable, or a ground wire other than those that are indicated in
User's Manual.
Doing so may cause fire.
• Do not insert materials in a vent hole.
Doing so may cause an electric shock and/or fire leading to personal injury.
• Do not put a cup with liquids such as water on the printer.
Doing so may cause an electric shock and/or fire leading to personal injury.
• Do not touch the fuser and other parts when opened the cover.
Doing so may result in getting burns.
• Do not throw toner cartridges and image drum cartridges into fire. Doing so may cause dust
explosion leading to get burns.
• Do not use an inflammable spray near the printer. Failure to follow may cause fire since there is
an area heating up within the printer.
• Pull the power plug out of the socket and contact with a customer's service centre when the cover
is unusually hot, smoking, giving off questionable odour, or making a strange noise.
There is a risk of fire.
• Pull the power plug out of the socket and contact with a customer's service centre when a liquid
such as water enters in the internal parts of the printer.
There is a risk of fire.
• Pull the power plug out of the socket and remove foreign materials such as clips when they fall
inside the printer.
There is a risk of getting an electric shock and/or causing fire leading to personal injury.
• Do not operate and/or disassemble the printer other than that which is directed in User's Manual.
Doing so may cause an electric shock and/or fire leading to personal injury.
To Next Page
Loading...
Need help?
General
