Scanning With the Machine 6-23
" Text starting with the first character of the maximum 10 characters
is searched for. Text will not be found if the search keyword is in
the middle of a word.
8 Press the or key to select the desired data, and then press the ENTER
key.
" To check the found information, press the key.
" An e-mail address exceeding 64 characters cannot be specified. If
such an e-mail address is specified, ADDRESS IS TOO LONG
appears for about two seconds, and then the screen for specifying
the destination address appears.
" To narrow down the search results, press the BACK key, and then
perform step 7 again.
9 If desired, edit the registration name, and then press the ENTER key.
10 If desired, edit the e-mail address, and then press the ENTER key.
The settings are registered, and the DIAL REGISTER menu appears
again.
Editing/Deleting Speed Dial Destinations
Information registered as a speed dial destination can be edited or deleted.
" Machine key operations cannot be used to edit/delete an FTP address
or SMB address registered as a speed dial destination. These
addresses can be edited/deleted with the Setup Utility.
1 In the main screen (Scan mode), press the or key to select UTIL-
ITY
, and then press the ENTER key.
2 Press the or key to select DIAL REGISTER, and then press the
E
NTER key.
3 Press the or key to select SPEED DIAL, and then press the ENTER
key.
4 Use the keypad to type in the number (between 1 and 220) for the speed
dial destination to be edited/deleted, and then press the E
NTER key.
The information currently registered for the speed dial destination
appears for two seconds.
5 Press the or key to select EDIT to edit information or DELETE to
delete the destination, and then press the ENTER key.
If DELETE was selected, the settings are deleted, and the DIAL REG-
ISTER
menu appears again.
6 Use the keypad to edit the registration name, and then press the ENTER
key.
To Next Page
Loading...
Need help?
General
