134
Chapter 4 Reprocessing Operations
ENDOSCOPE REPROCESSOR OER-Pro Operation Manual
Once activating the “AUTOMATIC PRINTING”, no additional operation for using
this function is required. Perform the normal operation for reprocessing process.
The printing is performed automatically as described below.
1. Perform reprocessing process according to the procedure described in
Section 4.9, “Reprocessing” on page 113.
2. At the end of the reprocessing process, the reprocessing results are
automatically printed.
3. The buzzer beeps and paper feed stops when printing is finished. Cut the
printed part of paper and ensure that the information is printed correctly.
• If the printout is not satisfactory and the error code is
displayed on the main control panel, prints the latest
reprocessing record by “PRINT LAST” to confirm whether the
reprocessing process is completed (If E94 is displayed,
perform the remedial action according to Section 8.1,
“Troubleshooting guide” on page 274.). Press the “FUNC
SEL” button on the control panel to select “PRINT LAST” and
then press the “START” button. If the printer prints the
reprocessing results, it shows that the previous reprocessing
process was successfully completed. If the printer prints the
error results, it shows that the previous reprocessing process
was interrupted by error indicated in the printed error results.
• For the printed information about “Reprocessing Result”,
refer to “PRINT FORMAT (Reprocessing Result)” on
page 145.
Print Option
Error occurred
during reprocessing
cycle
Error occurred when
starting
reprocessing cycle
(ex. E12, E31, E91)
Error occurred when
in standby
Error occurred
during
sub-independent
process
AUTOMATIC
PRINTING
–––
PRINT LAST
––
PRINT TODAY
–––
PRINT ALL
–––
Print option can print out the
subject error result
–
Print option cannot print out the
subject error result
Table 4.6
To Next Page
Loading...
Need help?
General
