76
Chapter 4 Reprocessing Operations
ENDOSCOPE REPROCESSOR OER-Pro Operation Manual
After the power activation, software version number is
displayed on the main control panel for only 500 msec. After
software version goes out, program number [1] and
estimated required time are displayed on the main control
panel, and the equipment is in standby.
Figure 4.3
2. Open the water faucet. Make sure that no water leaks from the equipment
and water supply hose connectors.
If the main and subcontrol panel displays do not turn ON
Set the power switch to OFF, wait for about 5 seconds, and then set the power
switch to ON again. If the same problem recurs, set the power switch to OFF and
contact Olympus.
Do not set the power switch to ON in less than 5 seconds
after setting it to OFF. Otherwise, the equipment may
malfunction or fail.
Software Version
Number (ex. Ver 3.05)
Estimated required time for
selected reprocessing program
Program Number
To Next Page
Loading...
Need help?
General
