274
Chapter 8 Troubleshooting and Repair
ENDOSCOPE REPROCESSOR OER-Pro Operation Manual
Chapter 8 Troubleshooting and Repair
When the cleaning/disinfection process is interrupted, the
scopes will not be properly cleaned and disinfected. In this
case, reprocessing should be started again from the
beginning.
If any irregularity is detected during an inspection or if the device is clearly
malfunctioning, do not use it. Contact Olympus for repair.
Some problems that appear to be malfunctions may be correctable by referring
to Section 8.1, “Troubleshooting guide” on page 274. If the problem cannot be
resolved by the described remedial action, do not use the device and contact
Olympus.
8.1 Troubleshooting guide
• Before handling the disinfectant solution, read the
precautions carefully and use it as instructed. It is especially
important to know what to do if the disinfectant solution
comes in contact with your skin.
• When handling the disinfectant solution, wear personal
protective equipment to prevent any disinfectant from getting
on your skin or being inhaled. Avoid direct physical contact
and inhalation of vapors. If any disinfectant solution gets in
your eyes, immediately rinse with a large amount of fresh
water and then consult a medical specialist. Personal
protective equipment, such as eyewear, face mask,
moisture-resistant clothing, and chemical-resistant gloves
that fit properly and are long enough so that your skin is not
exposed. All personal protective equipment should be
inspected before use and replaced periodically before it is
damaged.
• Do not put your hand behind the disinfectant solution bottle
drawer. Irritation of skin due to contact with concentrated
disinfectant solution, injury by touching a projection, or
malfunction of this equipment may result.
To Next Page
Loading...
Need help?
General
