5-22
OPERATION
Initial setting level
CHAPTER 5 OPERATION
5-14 Specifying the Decimal Point
Position
(K3MA-J/K3MA-F)
This parameter allows you to specify the decimal point position of the display value.
Procedure
A. When the product is at the operation level, press
the L key and hold it down for at least three
seconds to enter the initial setting level.
•"
5
" will appear on the level indicator, indicating
the product has entered the initial setting level.
B. Press the M key several times until parameter
"dp" appears on the main indicator.
C. Press the S key to display the set value of the
parameter.
• The current set value for the decimal point posi-
tion will appear on the main indicator.
D. Press the S key again.
• The set value starts blinking, indicating the prod-
uct is in the change state.
E. Use the U key to change the set value.
F. Press the M key to go to the next parameter.
• The change is saved.
G. Press the L key and hold it down for at least
one second to return to the operation level.
Parameter Set value
Description
dp
(DP)
\.\\\\
Readouts are given to four decimal places.
\\.\\\
Readouts are given to three decimal places.
\\\.\\
Readouts are given to two decimal places.
\\\\.\
Readouts are given to one decimal place.
\\\\\
Readouts are given as integers.
To Next Page
Loading...
Need help?
General
