Omron ns series User Manual

A-1 Comparison between NS-series PTs and CX-Programmer
A-1-2 Monitoring I/O Status of Ladder Program
101
A-1-2 Monitoring I/O Status of Ladder Program
Function NS Series CX-Programmer
Display execution status of the
program section
By color By color
Displaying special instruction
word data, TIM/CNT present
values
Display on the ladder Display on the ladder
Differentiation monitoring/Stop
monitoring
None Possible
Force-set/reset or set/reset Enabled for ladder diagrams or the
Multiple I/O Monitor.
Can be performed by specifying the
input bit/word on the ladder diagram.
Changing present values Possible, but floating-point values
cannot be changed.
Possible
Changing set values Possible Possible
Changing timer/counter set
values
Possible, but address-specified set
values cannot be changed.
Possible
When DM/EM indirect
addressing is used for
comparison instruction
operands
Time comparison instructions
Execution status is not displayed to
the right of comparison instructions.
(The ON/OFF status of input bits and
outputs, and present values for
operands used in special instructions,
are displayed.)
The upper part of a comparison
instruction is displayed in yellow.
Execution status is not displayed to
the right of comparison instructions.
(The ON/OFF status of input bits and
outputs, and present values for
operands used in special instructions,
are displayed.)
A-1-3 Search Program Section Function
Function NS Series CX-Programmer
Searching for input bits
(contacts)
Possible Possible
Searching for instructions Search input bit of output-group
instructions by Operation code +
Operand
Search all instructions by Operation
code + Operand
Searching for addresses Possible Possible
Searching for next/previous Possible Possible
Searching for comments/
strings
Not possible Possible
Jumping to the input bit’s
address (Jump to the program
section using the input bit of
cursor position on the ladder)
Possible Possible
Jumping to the program
section number
Not possible Possible
Searching from a PT screen
for addresses specified as
alarms
Possible Not possible
Returning to previous search
results
Possible Possible
Searching from an END
instruction onwards
Not possible Possible
Searching for address
(words)
Only the one word specified for an
operand is searched for.
All of the words used for the operand
(i.e., the number of words used by the
instruction) are searched for.
Specifying the first operand in
a JMP or JME search
Not possible Possible

Omron ns series Specifications

General

Brand	Omron
Model	ns series
Category	Touch terminals
Language	English