Omron ns series User Manual

3-1 Main Screen
3-1-4 Button Area
46
3-1-4 Button Area
The following buttons are used for executing the functions of the Ladder Monitor.
Displays the previous
program section.
Switches I/O comment displays
in the ladder display area to 3
rows, 1 row, or no display.
Displays the next program
section.
Switches present value displays
for I/O status monitoring and
multiple I/O monitoring to
hexadecimal, decimal, or signed
decimal.
Displays the following
search items in a pop-up
menu.
•
Search address
•
Jump
•
Search Output Instr.
Searches for the address
currently indicated by the
cursor.
Displays the following menu
items.
•
Monitor Hard Copy
•
Remove the Memory Card
•
Ladder Monitor Start/Stop
•
I/O Comment Reading
•
Change Host
•
PLC Error
•
Check Force Bits
•
Mode Change
•
Prog Console Start
•
Various Settings
•
Programming Console
Setting
•
Address Search Setting
•
Search Timeout Watch
Time Setting
•
I/O Comment File Setting
Re-reads program sections
that were previously
searched. Can go back a
maximum of 30 searches.
Exits the Ladder Monitor and
returns to the user screens. (If
the Ladder Monitor was started
from the System Menu, the
display will return to the user
screen displayed prior to moving
to the System Menu.)
Displays or hides the
Multiple I/O Monitor. (20
addresses maximum can
be displayed for the NS15,
16 maximum for the NS12,
or 12 maximum for the
NS10/8.)
Scrolls up one row if the
program section that was found
exceeds the screen display
area. This button is displayed
only when scrolling is required.
Used to change the present
value or the set value for
the address currently
indicated by the cursor.
A bit set/reset, force-set/
reset, force-cancel, word
PV change, or timer/
counter SV change can be
executed.
Scrolls down one row if the
program section that was found
exceeds the screen display
area. This button is displayed
only when scrolling is required.

Omron ns series Specifications

General

Brand	Omron
Model	ns series
Category	Touch terminals
Language	English