Omron ns series User Manual

3-12 Starting the Programming Console
3-12-2 Starting the Programming Console Function
85
Serial Communications
Board
Communications Unit Connect to
CPU Unit
CPU Unit
Peripheral
port
(RS-232C)
CPU
Unit
RS-232C
Port
CS1W-
SCB21
(RS-232C)
CS1W-
SCB41
(RS-232C/
RS-422)
CS1W-
SCU21
(RS-232C)
CJ1W-
SCU41
(RS-232C/
RS-422)
CJ1W-
SCU21
(RS-232C)
CP1H-XA40DR-A,
CP1H-XA40DT(1)-D
Yes No No
CP1H-X40DR-A,
CP1H-X40DT-D
Yes No No
CP1H-Y20DT-D
Yes No No
CP1L-L14DR-A/D,
CP1L-L14DT(1)-D
Yes No No
CP1L-L20DR-A/D,
CP1L-L20DT(1)-D
Yes No No
CP1L-M30DR-A/D,
CP1L-M30DT(1)-D
Yes No No
CP1L-M40DR-A/D,
CP1L-M40DT(1)-D
Yes No No
1) If a Programming Console is connected to the peripheral port of the CPU Unit while
operating the Programming Console function on the PT connected to the RS-232C
port of the CPU Unit, the Programming Console function of Ladder Monitor will be
disabled.
2) When the PT is connected to the peripheral port of the PLC, a CS1W-CN118
RS-232C Conversion Cable is required.
Note
To use the Programming Console function, the following settings are required.
• Set the unit number to 0 on the Comm. Tab of the System Menu of PT.
The Programming Console function will not operate if any number except 0 is set for
the unit number.
• Turn OFF pin 1 of DIP switch on the PLC to enable writing.
If pin 1 is ON, the Programming Console function will not operate.
3-12-2 Starting the Programming Console Function
Note
• If touch switches are pressed in rapid succession, their inputs may not be
successfully received. Confirm that the input of a touch switch has been
successfully received before pressing the next touch switch.
• Press the Exit Button to end the Programming Console function after the operation.
Do not remove the cable or turn OFF the power to the PT while operating the
Programming Console function. Doing so may cause a communications error
between the PLC and PT.
1. Press the Menu Button in the Ladder Monitor Main Menu and select Prog Console
Start from the menu.
2. A confirmation dialog box will appear. Press the OK Button to start the Programming
Console function. Press the Cancel Button to exit the confirmation dialog box.

Omron ns series Specifications

General

Brand	Omron
Model	ns series
Category	Touch terminals
Language	English