1-1 Overview and Features
1-1-8 Functions Added in Version 3.1
21
• Word present values can be displayed and input in hexadecimal, decimal, or signed
decimal.
• Up to 65,535 global comments and 65,535 local comments can be displayed as I/O
comments.
• A Memory Card removal function has been added.
• The current program name can be displayed.
• Forced status can be checked when starting and stopping the Ladder Monitor.
1-1-8 Functions Added in Version 3.1
The following functions have been added for Ladder Monitor version 3.1.
• Monitoring is now supported for CJ2 CPU Units. (Tag names, however, are not
displayed.)
• EtherNet/IP can be used to connect to a PLC.
• The following new instructions for CJ2 CPU Units are now supported: TRSET,
GRAY_BIN, GRAY_BINL, BIN_GRAY, BIN_GRAYL, MAXD, MAXF, MAXL, MIND,
MINF, MINL, RECV2, SEND2, CMND2, PMCR2, and tracking instructions (RSRCH
and RSORT).
• A password function has been added. A password can be required before the
following operations: Changing present values, changing timer/counter set values,
changing the operating mode, and starting the Programming Console function. The
operation will be disabled if the password is incorrect.
1-1-9 Functions Added in Version 3.2
The following functions have been added for Ladder Monitor version 3.2.
• Support was added for the high-speed data exchange instructions for certain
Special I/O Units and CPU Bus Units that were added to unit version 1.1 of the CJ2
CPU Units.
To Next Page
Loading...
Need help?
General
