Mount the Base Module
Hardware Installation 3-11
3.
Push the module into the rack to engage the bottom and center side tabs.
4. Push the module into the rack until the front side-tabs approach the front of the
rack rails.
5. Lift the module up slightly, push it into the rack, and set the front tabs down on
the rack rail.
Task 2 Remove the Cartridge Magazine
1. Insert the hex key in the access hole at the lower inside corner of the cartridge
magazine (see Figure 3–11).
2. Align the hex key shaft parallel with the magazine face.
3. Push the tool slowly into the hole to release the latch located behind the touch
screen, and hold the hex key in place.
4. Grasp the cartridge magazine opening with your other hand, and pull the
magazine a short distance out of the library.
5. Remove the hex key and store it for future use.
6. Support the bottom of the magazine with your other hand during removal.
7. Pull the magazine out of the module, and set it aside.
8. Remove the cartridge magazine from the other side of the base module.
Figure 3–11 Magazine Latch Release
Note: If the module does not fit properly, remove it from the rack.
Adjust the rail spacing as necessary. Never bend the base module
side tabs.
Note: If you cannot engage the rails properly, remove the module
and adjust the rails. Never bend the tabs to engage a rail.
To Next Page
Loading...
Need help?
General