Expansion Module Installation
Hardware Installation 3-15
Gather the Expansion Module Attachment Hardware
Perform the following instructions to gather attachment hardware:
1. Remove the contents from the accessory package.
2. Inventory the items to make sure you have everything to install the module.
3. Select the items appropriate for installation in your rack, and set the others aside.
Power Down the Library
Task 1 Power Down the Library
1. Quiesce the host application to prevent disruption of active storage operations.
2. Log in to the SL150 remote interface (see Figure 4–15).
3. Click the power icon in the upper left of the screen (see Figure 3–15), and select
Power Down Library from the list.
Figure 3–15 Power Down Options
Illustration Legend:
1 - Power Icon
2 - Power Down Library Command
4. Select the Prepare the Robot for removal before the library powers down check
box, and click OK (see Figure 3–16).
Note: Always use the back rails, module labels, and the expansion
cable. Use the hook and loop strap and rivet as desired for cable
management. Use the clip nuts and 10-32 screws for racks with
square holes. Use the appropriate screws for threaded hole racks.
For example, a rack with M5 threaded holes uses the M5 screws
only (clip nuts, 10-32 X 5/8 screws, and M6 screws are not used).
Note: During the initial library installation, continue with
"Remove the Library Floor" if you are installing the expansion
module
To Next Page
Loading...
Need help?
General