Mount the Base Module
3-12 StorageTek SL150 Modular Tape Library Installation Manual
Task 3 Remove the Cable Clip
1. Locate the tag in the right cartridge magazine opening (see Figure 3–12).
2. Grasp the ring and pull down.
3. Discard the cable clip unless you intend to reship the library after rack installation.
Figure 3–12 Cable Clip Removal
Task 4 Secure the Base Module to the Rack
1. Insert a screw through the bottom hole of the base module and thread it a few full
turns.
2. Insert a screw into the bottom hole on the other side of the module and thread it a
few full turns (see Figure 3–1).
3. Fully tighten both retaining screws.
4. Replace the cartridge magazines if you are not installing expansion modules.
5. Continue with the section for the applicable task:
■ "Expansion Module Installation"
■ "Final Hardware Actions"
Note: Use the 10-32 screw when the rack has square mounting
holes (the screw mates with the clip nut).
Note: Use a 10-32, M5, or M6 screw depending on your rack
hardware.
Note: Left and right magazines are unique. Orient the magazine
so the cartridge openings face the Front Control Panel.
Do not put cartridges in the magazine slots.
To Next Page
Loading...
Need help?
General