Expansion Module Installation
3-16 StorageTek SL150 Modular Tape Library Installation Manual
Figure 3–16 Prepare Robot for Removal
Illustration Legend:
1 - Check Box
2-OKButton
Task 2 Lock the Robot
1. Locate the robot lock on the base module (see Figure 3–2).
2. Set the robot lock to the locked position.
If the robot lock is the type with a thumbscrew, remove the lock mechanism, rotate
it 180 degrees, insert the mechanism into the base module slot, and fully tighten
the thumbscrew.
If the robot lock is the type with a knob, grasp the knob and turn it
counter-clockwise until the pointer is past the line pointing toward the red, locked
padlock icon.
3. Make sure the locked padlock icon is indicated.
Remove the Library Floor
To remove the library floor:
1. Remove the cartridge magazines from the bottom module of the library (see
"Remove the Cartridge Magazine").
2. Grasp the finger holds on the front edge of the floor in the magazine bay (see
Figure 3–17).
3. Pull the floor out the front of the module, and set it aside.
Note: If the floor does not move, reach through the magazine
opening and push down on the floor behind the touch screen panel to
unseat the floor locking tabs. Then pull the floor forward with your
other hand.
To Next Page
Loading...
Need help?
General