Final Configuration
Library Initialization 4-15
Figure 4–15 SL150 Remote Interface Log In Screen
Illustration Legend:
1 - User ID
2 - Password
3-HelpLink
2. Refer to the user's guide or online Help (see call-out 3 in Figure 4–15) for further
instructions and information to:
■ Define other user roles.
■ Partition the library, if desired.
■ Alter tape drive settings, if desired.
Some configuration settings result in a reboot of the library.
3. Continue with Chapter 5, "Checkout and Host Connection" when the applicable
items above are complete.
Note: If you are not able to log in to the remote interface because
the network setting is wrong or you have forgotten the password,
you can reset the initialization values to the manufacturing default
(see "Reset the Library with Manufacturing Default Values").
Note: Library initialization occurs during the reboot and includes
movement of the robot to determine the number of modules and tape
drives in the library. If library initialization fails, the tape drive ports
are not enabled. Because this is a bridged library, the host will not be
able to see the library if the bridged drive ports are not enabled.
Perform library troubleshooting procedures to resolve a problem.
To Next Page
Loading...
Need help?
General