Run the Self-Test
5-2 StorageTek SL150 Modular Tape Library Installation Manual
2.
Click Library in the left navigation area.
The graphical library map appears containing a section for each installed module.
3. View the current library state at the top right of the screen.
4. Click Library is Online.
5. Select Set Library Offline (see Figure 5–1).
The Set Library Offline dialog box appears.
6. Click OK to continue or Cancel to exit.
Figure 5–1 Set Library Offline
Illustration Legend:
1 - Set Library Offline
Run the Self-Test
Task 1 Invoke the Self Test
1. Insert a diagnostic tape in the Mailslot, if the library does not have a reserved slot
containing a diagnostic tape.
2. Close the mailslot expansion first (if configured).
3. Push the Standard Mailslot into the library using a single, steady motion until it
latches into place with a noticeable click.
The library will not be able to access slot positions until the Mailslot is positively
latched.
Note: You can open the Mailslot from either the remote interface
or the touch screen on the base module. You might need to enable
the Locate indicator to help you identify the library and use the
touch screen.
Note: If you do not insert the Mailslot smoothly, you might fail to
engage the latch and trigger multiple re-audits of the Mailslot.
To Next Page
Loading...
Need help?
General