Step 4 of 6 (Set the Dr ive Element Addressing Mode)
Library Initialization 4-9
Set the Time Manually
To set the time manually:
1. Tap the Clear button to remove any existing time value.
2. Tap the screen keys to enter the current time in the format HH:MM:SS where HH
represents 24-hour format.
3. Tap the Done button.
The Set the Library Date and Time screen appears showing the values you entered.
4. Verify the values are correct and tap the Next button.
Step 4 of 6 (Set the Drive Element Addressing Mode)
Figure 4–10 Drive Element Addressing Modes
There are two drive element addressing modes:
Address All Drive Slots
All drives, including empty drive slots, are assigned a sequential SCSI element address
which is always reported to attached hosts. In this mode, the library does not need to
be restarted for newly installed drives to become usable by attached hosts, and drive
SCSI element addresses never change. Also, empty drive slots can be assigned to a
partition.
Address Only Installed Drives
Only installed drives are assigned a sequential SCSI element address. Empty drive
slots are not assigned a SCSI element address and are not reported to attached hosts.
In this mode, the library must be restarted before newly installed drives are usable by
attached hosts, and drive SCSI element addresses may change. Also, only installed
drives can be assigned to a partition.
Set the Drive Element Addressing Mode
To set the drive element addressing mode:
Note: Change any incorrect value by tapping the keyboard button.
To Next Page
Loading...
Need help?
General