Step 2 of 6 (Configure the Network Port 1)
Library Initialization 4-5
Enter the Host Name
Valid host names contain the following characters: A through Z, a through z, 0 through
9, and the hyphen (-). A hyphen cannot be the first or last character in the host name.
To enter the host name:
1. Tap the keyboard button.
2. Tap the Clear button to remove any existing Host Name value.
3. Tap the screen keys to enter the host name.
4. Tap the Next button after entering the last character of the name.
5. Use the Configure Network Port 1 for list to select an IP address type.
There are two options: IPv4 only or IPv4 and IPv6.
6. Tap the Next button.
A screen appears for defining IPv4 address parameters.
Configure Network Port 1 with an IPv4 Address
Figure 4–5 Network Port 1 Static IPv4 Address
Perform the following tasks to configure the network port.
Task 1 Configure IPv4 (Static or DHCP)
1. Use the Configure IPv4 list to select either Static or DHCPv4.
For a successful startup, DHCPv4 must be running on your network.
If Static is selected, you must enter additional information.
Task 2 Enter the Static IPv4 Address
1. Tap the Clear button to remove any existing IPv4 Address value.
2. Tap the screen keys to enter the IPv4 Address in the format XXX.XXX.XXX.XXX.
3. Tap the Next button after entering the last character of the address.
Note: Neither the space nor the underscore (_) is supported.
To Next Page
Loading...
Need help?
General