Expansion Module Installation
Hardware Installation 3-23
Task 2 Secure the Rear Rails
1. Push the back rail against the rack vertical rail.
2. Secure the back rail to the rack vertical rail with a screw.
3. Repeat this task for the rail on the other side of the module.
Task 3 Secure the Expansion Module to the Front Rack Stile
1. Insert a screw in the lower left side of the module and thread it a few turns.
2. Insert a screw in the lower right side of the module and thread it a few turns.
3. Fully tighten both screws.
4. Install another expansion module (see "Install Clip Nuts for the Expansion
Module").
Replace the Cartridge Magazines
Follow these instructions to replace the cartridge magazine:
1. Orient the magazine with the cartridge slots facing toward the center of the
module.
2. Lift the magazine and point the back toward the module slot.
3. Engage the magazine with the track in the magazine slot.
4. Push the magazine fully into the slot.
5. Repeat as necessary until each expansion modules has two magazines.
Label the Module
Follow these instructions to attach an identification label to the module:
1. Locate the scribe lines in the upper left corner of the expansion module (as viewed
from the back of the rack).
2. Obtain the module label sheet from the accessory kit.
3. Peel the proper label from the label sheet.
Tip: Use a 10-32 screw when a rack has square holes (the screw
mates with a clip nut).
Tip: Use a 10-32 screw when a rack has square holes (the screw
mates with a clip nut).
Note: Left and right magazines are unique.
Note: Do not put cartridges in the magazine slots.
Note: The sheet has labels for Module 2 through Module 10.
To Next Page
Loading...
Need help?
General