drive
Command Line Interface Reference B-7
config serviceInfo print
Displays the library service information.
config serviceInfo set
Sets service information: contact 'contactName' phone 'phoneNumber' streetAddr
'streetAddress' city 'city' state 'state' country 'country' zip 'zipCode' description
'description data'.
Currently the maximum string length is 31 characters. Each string must be delimited
by ' ' (single quotes) to provide the ability to use spaces and other characters.
Example:
SL8500> config serviceInfo set city 'Denver' contact 'Andy' country 'USA'
description 'Manager' phone '303 222-4444' state 'C0' streetAddr '1 tape drive'
zip '80027'
requestId
requestId 1512402
Device serviceInfo
Success true
Done
Failure Count 0
Success Count 1
COMPLETED
date
This command sets the library date in Greenwich Mean Time (GMT).
date
Displays help for the date command, the same as "help date".
date print
Displays the current system date.
date <MM> / <DD> / <YYYY>
Sets the system date. In a library complex, the library with libraryId = 1 is the master.
Change the date on the master library.
■ <MM> - two digit month
■ <DD> - two digit day
■ <YYYY> - four digit year
drive
This command displays information about the drives or executes the drive utilities
such as adiEnable, fastLoad, power, and rewindUnload.
drive
Displays help for the drive command, the same as "help drive".
drive adiEnable {on | off | print}
Turns on or off or prints status of drive discovery with ADI. Once enabled, any
subsequently added drives will attempt ADI drive discovery. To enable ADI for all
ADI capable drives in the library, the library must be rebooted.
To Next Page
Loading...
Need help?
General