Installation Tools
Installation Planning 2-13
■ Kit dimensions are: 99 cm (39 in.) long, 71 cm (28 in.) wide, and 51 cm (20 in.) high.
The kit comes with an extendable handle and wheels.
Track Stop Installation Tools
Both the rack alignment tool kit (418644901) and original track alignment (419894001)
tool have been distributed to regional depots. Service representatives can order and
check out the special tools as typically done for spare parts. Use two rack alignment
kits and two track alignment tools to work both sides of the library in parallel.
Installation time for five SEMs is approximately 5 hours.
The rack alignment tool kit (418644901) includes:
■ Short tool (418623102)
■ Long tool (418623002)
■ Serialized shipping container
Additional tools to be acquired locally:
■ 1/16 hex Allen driver — required
■ Step stool and knee pads — recommended
■ SL8500 Array Extraction Tool (24100275) — if available
The rack stops (418626901) are packaged in kits of 17 stops and are used in groups of
16 so spares will always be available.
Table 2–12 Installation Tools for Tool Kit
Description Part Number
Copper rail connector extraction tool 313921001
Frame jacks with handles (adjustable jack) 313880803 (check availability)
Serial cable for laptop 24100134
Crossover cable for laptop 24100163
Tape drive power kit 314831204
Torx screwdriver and bits Obtain locally
3/8-in. drive ratchet wrench with 6 in. extension
1/4-in., 3/8-in., and 5/16-in. socket for 3/8-in. drive
1/4-in. and 5/16-in. hex(Allen) on 3/8-in. drive
Obtain locally
3/4-in., 5/8-in., and 9/16 in. combination wrench Obtain locally
25 ft tape measure, 2 ft level Obtain locally
Utility knife, wire side cutters, rubber mallet Obtain locally
Flashlight, step stool, work gloves, safety glasses Obtain locally
Volt/Ohmmeter Obtain locally
Table 2–13 Rack Stops Per Library
SEMs Rack Stops Per Rail Total Rack Stops Per Library Quantity of PN 418626901
01 16 1
11 16 1
21 16 1
31 16 1
45 80 5
To Next Page
Loading...
Need help?
General