Overriding a CAP Reservation of a Partition
Operating a CAP 8-3
Removing a CAP Magazine from a Bulk CAP
Locking/Unlocking a CAP
Normally, the host software unlocks or locks a CAP. However, you can use the
following procedure if you cannot unlock the CAP through the host. An unlocked
CAP is reserved by the library and unavailable to all hosts until it is locked.
1. Attempt to unlock the CAP using the host software.
2. If you cannot unlock the CAP through the host, in SLC select Tools > Diagnostics.
3. Expand the CAP folder. Select the CAP to modify.
4. Click the Access tab.
5. In the Locked pull-down list select:
■ False to unlock.
■ True to lock.
6. Click Apply.
Overriding a CAP Reservation of a Partition
If the partition does not release the CAP reservation and you cannot terminate the
enter or eject command on the host, use this procedure to override the CAP
reservation.
1. In SLC, select Tools > Diagnostics.
2. Expand the CAP folder, and then select the CAP to override.
Note: If the CAP is reserved by a host, the host must release the CAP
reservation before you can unlock the CAP.
Note: You must follow all steps in this procedure, or the CAP could
become unavailable to all partitions.
To Next Page
Loading...
Need help?
General